Help with the appliance
en
51
--------
Note:
If you cannot rectify the fault yourself by turning the appliance off and then on
again, please contact our after-sales service.
Drying is taking too long.
■
The appliance may have fluff in it. This will increase the required dry-
ing time.Remove the fluff.
■
The heat exchanger may have fluff in it. Run the basic appliance care
programme.
■
If the air inlet on the appliance is blocked or not fully open, this may
increase the drying time. Make sure that the air inlet remains unob-
structed.
■
If the ambient temperature is lower than 15 °C or higher than 30 °C,
this may increase the drying time.
■
Inadequate air circulation in the room may increase the drying time.
Make sure the room is adequately ventilated.
Unpleasant odour in the appli-
ance
Run the intensive appliance care programme.
Humidity in the room is increas-
ing.
Make sure the room is sufficiently ventilated.
Unusual noises when drying.
When drying is in progress, the pump and compressor generate noise
when operating normally. This does not indicate that the appliance is
malfunctioning.
The appliance feels cold
despite drying.
Not a fault. The appliance can dry effectively at low temperatures using a
heat pump.
Drying programme is stopped. If the drying programme is stopped due to a power failure, restart the
programme or remove the laundry and spread it out.
Residual water in the conden-
sation container despite the
appliance being connected to
the drain hose*.
If the optional drain hose is installed, residual water remains in the con-
densation container due to the appliance's self-cleaning function.
* Depending on how the appliance is equipped or the available accessory
Summary of Contents for WTW87660GB
Page 1: ...en Installation and operating instructions Tumble dryer WTW87660GB ...
Page 57: ...6 ...
Page 58: ...6 ...
Page 59: ...6 ...