operation
en
31
The switch-on process takes a few
seconds.
12.2 Setting a programme
1.
Turn the programme selector and
set the required programme.
→
2.
If required, adjust the programme
settings.
→
12.3 Adjusting the pro-
gramme settings
Depending on the programme and
programme progress, you can adjust
or activate/deactivate the settings.
Requirement:
A programme is set.
"Setting a programme", Page 31
▶
Adjust the programme settings.
→
Note:
The programme settings are
not saved permanently for the pro-
gramme.
12.4 Loading laundry
Note:
To prevent creasing, note the
maximum load for the programmes.
→
Requirements
¡
The laundry is prepared and sor-
ted.
→
¡
The drum is empty.
1.
Open the door.
2.
Place the laundry in the drum.
3.
Close the door.
Ensure that there is no laundry
trapped in the door.
12.5 Starting the programme
Requirement:
A programme is set.
"Setting a programme", Page 31
▶
Press
Start/Reload
.
a
The display shows the programme
duration or the "Ready in" time.
a
After the programme has ended,
the display shows: "-0-" .
Note:
If "Hot" appears, the appliance
cools the laundry.
When "Hot" goes out, the laundry
has cooled down.
12.6 Adding laundry
After the programme starts, you can
remove or add laundry at any time.
Requirement:
A programme has
started.
→
1.
Press
Start/Reload
.
The cooling process starts auto-
matically after approximately 30
seconds and cools down the laun-
dry while the drum is rotating. If
you want to avoid or cancel the
cooling process, open the door.
→
2.
Open the door.
3.
Add or remove laundry.
4.
Close the door.
5.
Press
Start/Reload
.
12.7 Cancelling the pro-
gramme
1.
Press
Start/Reload
.
2.
Open the appliance door.
3.
Remove the laundry.
→
Summary of Contents for WTW87MH0TC
Page 51: ......