Installation and connection
en
13
Energy-saving tips
■
Spin the laundry before drying.
The drier the laundry, the shorter
the drying time will be, thus
consuming less energy.
■
Load the dryer with the maximum
load.
Note:
Do not exceed the maximum
load for the programs, as this
prolongs the drying time
and increases energy consumption.
■
Ventilate the room and keep the air
inlet on the dryer free to ensure air
exchange.
■
Clean the fluff filter after each drying
cycle. If the fluff filter is dirty,
the drying time is prolonged
and energy consumption is
increased.
■
Energy saving mode
: If the dryer is
not operated for a prolonged period,
it automatically switches off before
the program starts and when
the program has ended to save
energy. The display panel
and indicator lamps go off after
a few minutes and the Start button
flashes. To activate the lighting,
press any button, open or close
the dryer door or turn the program
selector.
5
Installation and
connection
Installation and connection
Scope of delivery
■
Dryer
■
Installation and operating
instructions
■
Basket for woollens
*
■
Condensation drain*
Installing and connecting the
dryer
:
Warning
Risk of death!
There is a risk of electric shock as the
dryer is operated with electricity.
■
Check the dryer for visible damage.
You must not operate the dryer if it is
damaged.
■
Before connecting the dryer to the
power supply, ensure that the
electric voltage specified on the
rating plate matches the voltage of
your socket.
■
Only use residual current circuit
breakers with the following
symbol:
z
.
■
Ensure that the mains cable is not
kinked or trapped, and that it does
not come into contact with heat
sources or sharp edges.
:
Warning
Children could lock themselves in
the dryer, putting their lives at risk!
Do not set up the dryer behind a door
or sliding door, as this may obstruct the
dryer door or prevent it from opening.
* Depending on the model
