Programme settings
en
25
--------
Iron Dry
ö
Normal, single-layered laundry that still needs to be damp after
drying and is suitable for ironing or hanging up.
(Adjust drying
level)
ó
5
5
5
5
5
5
If you think the laundry is still too damp when the drying pro-
gramme has ended, you can adjust the degree of dryness to
achieve a particular dryness level. To increase the dryness level,
set the degree of dryness to between
5
and
5
5
5
. This will
extend the programme duration but the temperature will remain
the same.
Once you have adjusted the degree of dryness for a pro-
gramme, this setting will be retained for the programme even
after the appliance has been switched off.
(Ready in)
ñ
‚
-
ƒ…
Before starting the programme
, you can preselect the pro-
gramme end time ("Ready in" time) in hourly increments (h =
hour), up to a maximum of 24 hours:
1.
Select a programme.
The programme duration will be displayed for the selected
programme, e.g.
‚
:
…†
(hours:minutes).
2.
Press
(Ready in)
ñ
repeatedly until the required number
of hours is displayed.
Note:
Use the
(Ready in)
ñ
+
button to increase the set-
ting values, and the
(Ready in)
ñ
–
button to reduce them.
3.
Press
(Start/Pause)
A
.
This activates the time delay.
Before the programme starts, the selected number of
hours (e.g.
‰
) is shown on the display and counts down
until the drying programme starts. The duration of the pro-
gramme will then be displayed.
Note:
The programme duration is included in the "Ready in"
time.
E.g.
\
‹
:
…‹
The drying time for
timed programmes
can be extended to up
to 3 hours 30 minutes in 10-minute increments.
