en
Home Connect
46
5.
Press
}
Inicio remoto
.
Flex start
appears in the display.
The
FlexStart
function has now been
activated and the appliance will wait to
be remotely started by the smart energy
system (Energy manager).
: Ready in approx.
appears in the
display. The smart energy system
(energy manager) has set a time at
which your appliance can start. The
program will end after the specified
time.
Notes
■
If the smart energy system (Energy
manager) does not start your
appliance, the programme will still
be started before the set time period
ends.
The programme will end when the
time period ends.
■
For safety reasons,
}
Inicio remoto
and in turn the
Flex start
function will
be deactivated in the following
circumstances:
– Press Inicio/Pausa+Carga (Start/
Pause)
A
.
– Open the door.
– Programme end.
– Press
#
to switch off the
appliance.
– Power failure.
If the
Flex start
function is
deactivated, the
Terminado en/em
(Finished in)
(Finished in) will
remain active.
Adding more laundry or removing
laundry:
Note:
If the
Flex start
function has
already been activated but the
programme has not yet started, you will
still be able to load more laundry or
remove some from the drum.
1.
Press
Inicio/Pausa+Carga (Start/
Pause)
A
.
2.
Open the door.
3.
Add or remove laundry.
4.
Close the appliance door.
5.
Press
Inicio/Pausa+Carga (Start/
Pause)
A
.
6.
Press
}
Inicio remoto
.
The
FlexStart
function has now been
activated and the appliance will wait to
be remotely started by the smart energy
system (Energy manager).
Intelligent program
recommendation
After you have washed your laundry in
the washing machine, the dryer will
recommend a suitable program for
drying your laundry.
The expected duration of the
recommended program is determined
based on the washing program you just
used.
To determine the best drying program
to use, your appliances must transmit
and receive information.
Therefore please note the following:
■
Before the data can be transmitted,
the washing program must run
through to the end.
■
The washing machine must be
Home Connect-capable.
■
The washing machine and dryer
must be connected to your home
network and registered in your
Home Connect app.
1.
Switch on the appliance.
2.
Set the program to
Smart Dry
Ç
.
The analysis starts.
3.
To cancel the analysis, set a different
program or switch the appliance off.
If an appropriate program has been
found, the LED associated with the
recommended program will be lit
continuously. If necessary, confirm the
notifications on the display. The
program information will then be shown
on the display.
Summary of Contents for WTX87EH0ES
Page 75: ...6 ...
