en
Help with the appliance
68
3
Help with the appliance
Help with the appliance
Faults
Cause/Remedy
Appliance does not start
Check the mains plug and the fuses.
The appliance does not
respond to inputs and the dis-
play shows: Please clean lint
filter
■
If there is fluff or debris in the fluff filter or if the fluff filter is damp,
this may impair the airflow in the appliance at low ambient tempera-
tures.
– Clean the base unit and dry the fluff filter thoroughly.
– Switch the appliance off and on again.
– Press
Inicio/Pausa+Carga (Start/Pause)
A
to restart the
programme.
Creasing.
■
Load exceeded or incorrect programme selected for a type of fabric.
All the required information can be found in the programme
table.
■
Remove laundry from the drum as soon as the drying programme
has finished. Creasing occurs when clothing is left in the drum.
Water is leaking out.
■
The appliance may be positioned at an angle. Level the appliance.
■
In the base unit, make sure that:
– The heat exchanger cover is properly locked.
– There is no dirt or debris on the heat exchanger cover's seal.
■
If the optional drain hose* is installed, make sure that the drain hose
The appliance is paused but the
drum is turning.
The appliance has detected a high temperature and has started the
CoolDown process. Temperature regulation can take up to 10 minutes.
You can cancel the CoolDown process at any time by opening the door.
The programme does not start Make sure that:
■
The door is closed
■
The Bloquear 3 seg. (Child Lock 3 sec.) has been deactivated
■
You have pressed Inicio/Pausa+Carga (Start/Pause)
A
Note:
If the programme has been delayed by setting
Terminado en/em
(Finished in)
(Finished in), the programme starts at a later point.
Programme duration displayed
changes as drying progresses.
Not a fault. The moisture sensor measures the residual moisture in the
laundry and adjusts the programme duration (with the exception of timed
programmes).
Summary of Contents for WTX87EH0ES
Page 75: ...6 ...