en
Home Connect
40
■
For safety reasons,
}
Remote Start
and, in turn, are deactivated in the
following circumstances:
– Press Start/
A
Pause.
– Open the door.
– Press
#
to switch off the
appliance.
– Power failure.
If the function is deactivated, the
M
Finished in
ñ
N
remains active.
Adding more laundry or removing
laundry:
Note:
If the function has already been
activated but the programme has not
yet started, you will still be able to load
more laundry or remove some from the
drum.
1.
Press
Start/
A
Pause
.
2.
Open the door.
3.
Add or remove laundry.
4.
Close the appliance door.
5.
Press
Start/
A
Pause
.
6.
Press
}
Remote Start
.
The
FlexStart
function has now been
activated and the appliance will wait to
be remotely started by the smart energy
system (Energy manager).
Intelligent program
recommendation
After you have washed your laundry in
the washing machine, the dryer will
recommend a suitable program for
drying your laundry.
The expected duration of the
recommended program is determined
based on the washing program you just
used.
To determine the best drying program
to use, your appliances must transmit
and receive information.
Therefore please note the following:
■
Before the data can be transmitted,
the washing program must run
through to the end.
■
The washing machine must be
Home Connect-capable.
■
The washing machine and dryer
must be connected to your home
network and registered in your
Home Connect app.
1.
Switch on the appliance.
2.
Set the program to
Smart Dry
Ç
.
The analysis starts and an animation
appears in the display.
3.
To cancel the analysis, set a different
program or switch the appliance off.
Once the right programme is found, the
animation stops, the LED for the
recommended programme lights up
permanently and programme
information is shown in the display.
4.
Press
Start/
A
Pause
.
Note:
If a suitable program cannot be
found, an audible signal will sound and
{ {{
will appear on the display.
Possible reasons:
■
No suitable drying programs could
be found for the selected washing
program.
■
The washing machine and dryer
must be connected to your home
network and registered in your
Home Connect app.
■
Check whether your appliances are
within range of your home network.
■
No data is available for the last wash
program used. The data is stored for
24 hours and then deleted.
■
The washing program was aborted.
The washing program must run
through to the end.
Summary of Contents for WTX87P90IL
Page 63: ...6 ...
