Appliance care
en
51
2.
Turn the condensation container
180° onto its underside and insert
the stopper.
3.
Clean the filter in the condensation
The condensation container is now
ready for the appliance care
programme.
Note:
If you are draining the
condensation water from the appliance
using the drain hose, reverse these
steps
after
running the basic or
intensive appliance care programme.
Running the basic appliance
care programme
To remove any dirt deposits in the
appliance, you can run the basic
appliance care programme.
Notes
■
After a certain period, your appliance
will automatically recommend that
you run the basic appliance care
programme.
’§“
will then appear on
the display for 5 seconds before the
programme starts, and again once
the programme ends. This message
will appear repeatedly until you have
run the basic appliance care
programme through to the end.
■
The basic appliance care
programme runs for approximately
one hour.
Run the appliance care programme as
follows:
1.
Prepare the appliance for appliance
care.
2.
Set the programme to position 1.
3.
Press and hold
ü
Drying Target
Š
. At the same time:
4.
Set the programme to position 4.
’˜‚
and the programme duration will
now alternate on the display.
5.
Pour approx. 1
^
litre of warm tap
water into the condensation
container.
Note:
Hold the full condensation
container horizontally at all times so
that no liquid spills out.
#
+
3
;
#
+
3
;
Summary of Contents for WTX87P90IL
Page 63: ...6 ...
