Home Connect
en
37
Flex start
Activate the
Flex start
function to allow
your smart energy system (Energy
manager) to start your appliance once
your home photovoltaic system is able
to provide sufficient energy or the
energy tariff is good.
Note:
Your smart energy system
(Energy manager) cannot start your
appliance until it is connected to the
appliance.
Activate
Flex start as follows:
1.
Select the programme you require.
2.
Use the
N
and
M
selection buttons
for the "Finished in" time to set the
required time.
3.
Press
A
(Start/Pause).
4.
Press
}
(Remote Start).
£
appears in the display.
The
FlexStart
function has now been
activated and the appliance will wait to
be remotely started by the smart energy
system (Energy manager).
If the time changes on the display to
„
.
‹œ
, for example, the smart energy
system (Energy manager) has
established a time at which your
appliance can start. The programme will
end after the specified time.
Notes
■
If the smart energy system (energy
manager) does not start your
appliance, the programme will still
be started before the set time period
ends.
The programme ends when the time
period ends.
■
For safety reasons,
}
and, in turn,
Flex start
are deactivated in the
following circumstances:
– Press
A
.
– Open the door.
– Press
#
to switch off the
appliance.
– Power failure.
If the
Flex start
function is
deactivated, the
M
ñ
˜
(Finished
in) remains active.
Adding more laundry or removing
laundry:
Note:
If the
Flex start
function has
already been activated but the
programme has not yet started, you will
still be able to load more laundry or
remove some from the drum.
1.
Press
A
(Start/Pause).
2.
Open the door.
3.
Add or remove laundry.
4.
Close the appliance door.
5.
Press
A
(Start/Pause).
6.
Press
}
(Remote Start).
The
FlexStart
function has now been
activated and the appliance will wait to
be remotely started by the smart energy
system (Energy manager).
Intelligent program
recommendation
After you have washed your laundry in
the washing machine, the dryer will
recommend a suitable program for
drying your laundry.
The expected duration of the
recommended program is determined
based on the washing program you just
used.
To determine the best drying program
to use, your appliances must transmit
and receive information.
Therefore please note the following:
■
Before the data can be transmitted,
the washing program must run
through to the end.
■
The washing machine must be
Home Connect-capable.
■
The washing machine and dryer
must be connected to your home
network and registered in your
Home Connect app.
1.
Switch on the appliance.
2.
Set the program to
Smart Dry
Ç
.
The analysis starts and an animation
appears in the display.
Summary of Contents for WTX8HKP9SN
Page 63: ...6 ...
