en
Installation and connection
14
During installation, ensure that:
■
The dryer is placed on a clean, level
and firm surface,
■
The mains plug can be accessed at
all times,
■
The area around the dryer is kept
clean and
■
The dryer is levelled using the
threaded feet.
Note:
Check the alignment of the
appliance with a spirit level and
correct if necessary. Change the
height by turning the appliance feet.
All appliance feet must stand firmly
on the ground.
Incorrect alignment may cause high
noise levels, vibrations and improper
movement of the drum.
Note:
If in doubt, have the appliance
connected by a specialist.
Changing the side on which
the door is hinged
Proceed as follows to change
the side on which the door is hinged:
1.
Set the programme selector to the
"Off" position, disconnect the dryer
from the mains and open the door.
2.
Remove the screws from the dryer
and then remove the dryer door.
Note:
Use a T20 (Torx) screwdriver
only. Do not use any other tools to
change the side on which the door is
hinged.
3.
Carefully place the dryer door onto a
flat surface, and place a hand towel
or other such item between the door
and the surface to avoid scratching
or damaging the door.
4.
Now remove the screws from the
door hinge, and remove the hinge
from the dryer door.
Summary of Contents for WTY877W0AU
Page 1: ...en Installation and operating instructions Tumble dryer WTY877W0AU ...
Page 42: ...6 ...
Page 43: ...6 ...