Installation and connection
en
15
8.
Pull the filter out of the lock-in slot
and place it into the recess in the top
of the condensation container.
9.
Slide in the condensation container
until it clicks into place.
The condensation is now discharged via
the drain hose into the waste-water
system or into a wash basin.
Note:
If you want to change the
condensation drain back to the
condensation container, carry out all
these steps in reverse order.
Changing the side on which
the door is hinged
Proceed as follows to change the side
on which the door is hinged:
1.
Set the programme selector to the
"Off" position, disconnect the dryer
from the mains and open the door.
2.
Remove the screws from the dryer
and then remove the dryer door.
Note:
Use a T20 (Torx) screwdriver
only. Do not use any other tools to
change the side on which the door is
hinged.
3.
Carefully place the dryer door onto a
flat surface, and place a hand towel
or other such item between the door
and the surface to avoid scratching
or damaging the door.
4.
Now remove the screws from the
door hinge, and remove the hinge
from the dryer door.
Summary of Contents for WTYH7709ES
Page 1: ...en Installation and operating instructions Tumble dryer WTYH7709ES ...
Page 42: ...6 ...
Page 43: ...6 ...
