en
Faults and what to do about them
42
3
Faults and what to do about them
Faults and what to do about them
Faults
Cause/remedy
Please empty conden-
sate container
on the
display panel and drying
has stopped.
■
Empty the condensation container;
■
If the optional condensation drain* has been installed, the drain hose may
be blocked or kinked. Check the hose for deposits and flush the hose
through. Lay the hose without any kinks.
Please clean lint filter
on the display panel.
Clean the fluff filter and press the Start button
Heat exchanger is
being rinsed
on the dis-
play panel.
Not a fault. The heat exchanger is cleaned automatically. Do not pull out the
condensation container while this is displayed.
Dryer will not start.
■
Mains plug plugged in or fuse/circuit breaker checked?
■
Programme selected?Select a programme.
■
Dryer door open? Close the door.
■
Is the childproof lock activated? Deactivate childproof lock.
■
"Ready in" time selected? Programme starts after a delay
.
¢
on the display panel. Wi-Fi is switched on but a connection to your home network cannot be estab-
lished.Check whether your home network is available or try to connect to your
home network again.
Home Connect is not
working.
■
You can find solutions to problems with Home Connect at www.home-con-
nect.com.
■
The availability of the Home Connect functionality depends on the availabil-
ity of the Home Connect Services in your country. Home Connect Services
are not available in every country – for further information please check:
www.home-connect.com.
Creasing.
■
Creasing occurs when you have exceeded the maximum load or selected
the wrong programme for the type of fabric. All the required information
can be found in the programme table
.
■
Remove clothes immediately after drying; creasing will occur if they are left
in the drum.
Water is leaking out.
Not a fault; the dryer may be positioned on an incline. Level the dryer.
Programme duration dis-
played changes during
drying.
Not a fault. The moisture sensors detect the remaining moisture in the load and
adjust the programme length accordingly (except timed programmes).
* Depending on the model