Bosch WZ18, Installation Manual

Integrated IR Bullet Camera

Safety | en       

9

Electronic Surveillance -

 This device is intended for use in

public areas only. U.S. federal law strictly prohibits
surreptitious recording of oral communications.

Environmental statement -

 Bosch has a strong commitment

towards the environment. This unit has been designed to
respect the environment as much as possible.

Electrostatic-sensitive device -

 Use proper CMOS/MOS-FET

handling precautions to avoid electrostatic discharge.

NOTE: Wear required grounded wrist straps and observe proper

ESD safety precautions when handling the electrostaticsensitive
printed circuit boards.

Fuse rating -

 For security protection of the device, the branch

circuit protection must be secured with a maximum fuse rating
of 16A. This must be in accordance with NEC800 (CEC Section
60).

Moving -

 Disconnect the power before moving the unit. Move

the unit with care. Excessive force or shock may damage the
unit and the hard disk drives.

Outdoor signals -

 The installation for outdoor signals, especially

regarding clearance from power and lightning conductors and
transient protection, must be in accordance with NEC725 and
NEC800 (CEC Rule 16-224 and CEC Section 60).

Permanently connected equipment -

 Incorporate a readily

accessible disconnect device in the building installation wiring.

Pluggable equipment -

 Install the socket outlet near the

equipment so it is easily accessible.

Power resupply - 

If the unit is forced to power down due to

exceeding the specified operating temperatures, disconnect

the power cord, wait for at least 30 seconds, and then
reconnect the power cord.

Power lines -

 Do not locate the camera near overhead power

lines, power circuits, or electrical lights, nor where it may
contact such power lines, circuits, or lights.

Bosch Security Systems, Inc.

Installation Manual

| 1.0 | 2011.01