B4205
MAINTENANCE
REPLACING THE DUSTBAG
Always operate the cleaner with the dustbag installed.
If you forget to attach the dustbag or attach it in the wrong manner, the dust cover may not
close completely.
After removing the flexible hose, open the front cover using the compartment open button.
(fig. 20)
Rotate the support of the bag to the vertical position.
Remove the dustbag and insert a new one. (fig. 21)
Close the cover by pressing down until it clicks. (fig. 20)
The dustbag reference number is U62.
BLOCKED AIRFLOW AND DIRTY FILTERS
The cleaner stops automatically if a blockage occurs in the nozzle/tube/hose or if the filters are
blocked with dirt.
Disconnect from mains and allow the cleaner to cool for 45-60 minutes. Remove blockage
and/or clean filters.
Restart the cleaner.
REPLACING THE FILTERS
The dustbag must be replaced if the window of the dustbag full indicator is illuminated when
the cleaner is operating at maximum power and the nozzle is raised from the floor.
Filters should be replaced at least twice a year or when they become visibly soiled.
Always operate the cleaners with filters installed to avoid reduced suction.
Disconnect from electrical outlet before cleaning filters.
Replacing the motor filter
Pull dustbag upward and remove the motor protection filter. (fig. 22)
Put a new motor filter into the cleaner and close the front cover.
Replacing the exhaust filter
Open the filter grill to remove the exhaust filter with grill. (fig. 23-24)
Take off the filters from the grill. (fig. 25)
Put a new filter back on to the filter grill. (fig. 25)
Put the filter with grill back into the cleaner. (fig. 24)
Close the filter grill. (fig. 23)
ifu_4205.qxd 2003.07.08. 10:07 Page 8
