11
Operating the Unit
fig.05
1.
Turn on the effect
After you have finished making the connec-
tions (p. 9), press the pedal switch to turn
the effect on
(CHECK indicator lights red)
.
* This operation cannot be performed in HOLD mode.
* The unit functions differently depending on how
you have it hooked up. Refer to “Setting the
Output Method” (p. 16).
2.
Select the mode
Use the MODE switch to select the mode
to be used.
* Operations vary according to the mode. Refer to
each operation.
3.
Adjust the delay time
Fine tune the delay time with the D.TIME
knob.
4.
Adjust the feedback level
Use the F.BACK knob to adjust the feed-
back level (or how much the sound is re-
peated).
* Oscillation may occur with certain input
sounds, or when the knob is set at certain
positions.
5.
Adjust the volume
Adjust the volume level of the effect
sound with the E.LEVEL knob.
4
3
2
5
DD-6_e.book 11 ページ 2006年7月25日 火曜日 午後3時37分