18
Quick Start
Turning On the Power
Once the connections have been completed (p. 17), turn on power to your various devices in
the order specified. By turning on devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
1
Before you turn the power on, make sure of the following points.
• Are external devices connected correctly?
• Is the volume level of the DR-670 or connected amp turned all the way down?
2
Turn on the POWER switch located on the rear panel of the DR-670.
fig.00-03
3
Turn on the power of the amp.
4
While tapping the key pad, rotate the VOLUME knob on the rear panel to adjust the DR-
670’s volume level.
fig.00-04
Also adjust the volume levels for amps and other connected gear.
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is
required before the unit will operate normally.
■
Turning Off the Power
1
Before turning off the DR-670’s power, make sure that:
• Is the volume level of the DR-670 or connected amp turned all the way down?
2
Switch off any amps and other external equipment.
3
Turn off the power of the DR-670.
DR-670.e.book 18 ページ 2006年10月18日 水曜日 午後3時12分
Summary of Contents for Dr. Rhythm DR-670
Page 15: ...15 Memo DR 670 e book 15...
Page 117: ...117 Memo DR 670 e book 117...
Page 118: ...118 Memo DR 670 e book 118...