14
Turning On the Power
Once the connections have been completed, turn on power to your various devices in the
order specified. By turning on devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
1.
Before turning on the power, check the following points.
- Have connections with external devices been made correctly?
- Has the volume of the DR-770 and the connected amp system been turned to the
minimum position?
2.
Turn on the POWER switch located on the rear panel of the DR-770.
fig.01-02a
3.
Turn on the power of your amp system.
4.
While striking the pads, rotate [VOLUME] to adjust the volume of the
DR-770.
fig.01-03a
Adjust the volume of the connected amp system to an appropriate level.
This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is
required before the unit will operate normally.
Turning Off the Power
1.
Before you turn off the power, check the following points.
- Have the volume controls of the DR-770 and the connected amp system been turned to
the minimum position?
2.
Turn off the power of the amp system.
3.
Turn off the power of the DR-770.
POWER
AC IN 14V
700mA
OUT
IN
R
L(MONO)
INDIVIDUAL
PEDAL SW
OUTPUT
PHONES
ON
OFF
USE BOSS BRC
ADAPTOR ONLY
MADE IN JAPAN
MIDI
On
Off
NOTE
Summary of Contents for Dr. Rhythm DR-770
Page 119: ...119 MEMO...
