57
Chap.4
Chapter 4. Editing a Pattern
Deleting an Individual Note
Perform the steps below to delete only a single note from a
pattern.
1.
Press [SONG/PTN] so the display indicates
“PATTERN.”
The DR-770 is now in Pattern mode.
2.
Press [REAL/STEP] so the display indicates “STEP.”
This selects Step Recording.
3.
Use [VALUE*] to select the desired pattern (user
pattern).
4.
Press [REC].
The REC indicator will light.
5.
Press [START].
The tempo indicator will light.
6.
Use [RWD] [FWD] to select the step at which the
instrument you want to delete was recorded.
7.
Press [CURSOR
] to select the instrument that you
want to delete.
Each time you press [CURSOR
], each instrument that
was recorded at the selected step and its velocity will be
displayed, blinking alternately.
To return to the previous display, press [
CURSOR].
Pressing [ENTER] here will play the instrument
currently selected.
fig.104-01a
8.
Hold down [DELETE] and press [ENTER].
The instrument will be deleted.
MEMO
You can also delete an instrument by holding down
[DELETE] and play back the pad to which the instrument is
assigned.
9.
To end the procedure, press [STOP/EXIT].
Adding an Individual Note
If you wish to add an individual note to a pattern, use the
following procedure.
1.
Press [SONG/PTN] so the display indicates
“PATTERN.”
The DR-770 is now in Pattern mode.
2.
Press [REAL/STEP] so the display indicates “STEP.”
Step Recording will be selected.
3.
Use [VALUE*] to select the desired pattern (user
pattern).
4.
Press [REC].
The REC indicator will light.
5.
Press [START].
The tempo indicator will light.
6.
Use [RWD] [FWD] to select the step at which you wish
to add an instrument.
7.
Strike the pad to which the instrument you want to
record has been assigned.
NOTE
A maximum of nine instruments can be recorded in the same step.
If you attempt to record more, the tenth and subsequent
instruments will be ignored.
NOTE
It is not possible to record two or more instruments of the same pad
number at the same step.
Adjusting the Volume of an
Individual Note
If you wish to adjust the volume (velocity) of an individual
note within a pattern, use the following procedure.
1.
Press [SONG/PTN] so the display indicates
“PATTERN.”
The DR-770 is now in Pattern mode.
2.
Press [REAL/STEP] so the display indicates “STEP.”
Step Recording will be selected.
3.
Use [VALUE*] to select the desired pattern (user
pattern).
4.
Press [REC].
The REC indicator will light.
5.
Press [START].
The tempo indicator will light.
QUANTIZE
BEAT
QUANTIZE
BEAT
QUANTIZE
BEAT
QUANTIZE
BEAT
Summary of Contents for Dr. Rhythm DR-770
Page 119: ...119 MEMO...
