rev 0922
KEY ON
KEY OFF
Fit the speaker brackets around the handlebar of the desired
installation location. Use the included Rubber Mounting Shims to
secure the speaker brackets.
Fasten the mounting bolts on the bottom of the speaker
brackets. Before fully tightening, adjust the speakers so they are
pointing directly at the rider. Proceed to tighten mounting bolts
securely, then connect the corresponding colored speaker wires
together.
Mount the In-Line Function Knob in a safe, easy to access location
where it will not impede the rider’s ability to drive safely.
1) Remove the seat.
2) You will need to locate the fuse box, generally near the battery.
3) Look for and identify the two wires needed, Sw12V and Ground (-).
4) Disconnect the negative battery terminal, before making any connections.
Connect the Red wire (+12V) to the identified Switched wire on the motorcycle.
Protect it by wrapping it with electrical tape and secure it.
Connect the Black wire (Ground, -) to the identified Ground wire on the motorcycle.
Protect it by wrapping it with electrical tape and secure it.
Reconnect the negative battery terminal and switch on motorcycle to test system.
*DISCLAIMER: Basic electrical knowledge and tools are required for
the following steps.
See the supplied user manual for complete power connection
instructions. Use the in-line function knob to control power.
OFF
ON
LOCK
OFF
ON
LOCK
To the function knob
wire connectors
Battery negative or
chassis ground
Red
Fuse
Black
