62
EFFECT Parameters > NOISE SUPPRESSOR
NOISE SUPPRESSOR
This effect reduces the noise and hum picked up by guitar pickups.
Since it suppresses the noise in synchronization with the envelope
of the guitar sound (the way in which the guitar sound decays over
time), it has very little effect on the guitar sound, and does not harm
the natural character of the sound.
Parameter
Value
Explanation
ON/OFF
OFF, ON
Turns this effect on/off.
THRESHOLD
0–100
Adjust this parameter as appropriate
for the volume of the noise. If the
noise level is high, a higher setting
is appropriate. If the noise level is
low, a lower setting is appropriate.
Adjust this value until the decay
of the guitar sound is as natural as
possible.
* High settings for the threshold
parameter may result in there
being no sound when you play
with your guitar volume turned
down.
RELEASE
0–100
Adjusts the time from when the
noise suppressor begins to function
until the noise level reaches “0.”
DETECT
This controls the noise suppressor based on the
volume level for the point specified in Detect.
GK INPUT
*1
Input volume from the GK IN jack.
* Set the GK SETTING parameter
SENS (p. 83) appropriately.
NORMAL
INPUT
Input volume from the GUITAR
INPUT jack.
NS INPUT
Noise suppressor input volume.
* When connected as illustrated
below, and you want to prevent
a spatial-type effects sound (such
as a delay sound) from being
eradicated by the NS, you should
set DETECT to “NS INPUT.”
Spatial-type effect
NS
DLY
INST1 OUT
Specifies the output volume of the
INST.
INST2 OUT
INST3 OUT
VARIATION
PATCH, 01–10
NOISE SUPPRESSOR settings can be
saved/loaded as ten variations.
A saved VARIATION can be loaded
into a different patch, which is
convenient when you’re creating
sounds.
*1 Setting available with GK PATCH.
FOOT VOLUME 1, FOOT VOLUME 2
This is a volume control effect.
Normally, this is controlled with the expression pedal connected to
the CTL 3, 4/EXP 1 jack or CTL 5, 6/EXP 2 jack.
Parameter
Value
Explanation
VOLUME MIN
0–100
Sets the volume when the heel of
the EXP Pedal is depressed.
VOLUME MAX
0–100
Selects the volume when the toe of
the EXP Pedal is depressed.
VOLUME
CURVE
SLOW1,
SLOW2,
NORMAL,
FAST
You can select how the actual
volume changes relative to the
amount the pedal is pressed.
NO
RM
AL
SLO
W
2
SLO
W
1
FAS
T
When the pedal
is fully raised
When the pedal
is fully advanced
Volume
PEDAL
POSITION
0–100
Adjusts the volume.
VARIATION
PATCH, 01–10
FOOT VOLUME settings can be
saved/loaded as ten variations.
A saved VARIATION can be loaded
into a different patch, which is
convenient when you’re creating
sounds.
These variations are shared with the
FOOT VOLUME setting in FX1–FX3.
