Assembly
1.
Remove spreader and components from carton.
Place Hopper on it’s front panel, insert two (2) 1/4-20
x 1/2” Hex Head Bolts through the Leg, flattened end of
Handle Brace, and holes in Hopper as shown. Install
Lockwashers and Nuts
but leave them loose to ease
assembly.
Repeat on opposite side.
2.
Slide Wheels onto each end of Axle with the longer
portion of the wheel facing the hopper. Secure Wheels
with 3/16” dia. x 2” Cotter Pins.
3.
Install Control Tube between the Control Tube
Braces and secure with (2) 1/4-20 x 1 1/2” Hex
Bolts, Lockwashers, and nuts.
5.
Slide the ends of the Control Tube Braces over the
studs on the Shutoff Bar Brackets, secure with Cotter
Pins. Attached opposite end of Control Tube to the
Handle Lever using 1/4 dia. Clevis and Cotter Pin. Make
sure Handle Lever operates freely.
Tighten all Nuts left
loose in Step 1.
4.
Stand spreader upright on Wheels. Attach Upper
Handle assembly to Handle Brace (make sure Handle
is positioned as shown) using (4) 1/4-20 x 1-1/2” Hex
Bolts, (4) Lock Washers, and (4) Nuts. Tighten securely.
Install Handle Grips onto Upper Handle. Slide Handle
Lever assembly between Handle Brackets and secure
with 1/4 dia, Clevis and Cotter Pin. Make sure Lever
pivots freely.
Leg
1/4-20 x 1/2”
Hex Bolt
Lock Washer
Nut
Handle Brace
3/16 x 2”
Cotter Pin
Drive Wheel
Lock
Washer
Nut
Handle Lever
Assembly
Handle Grip
Cotter Pin
1/4-20 x 1-1/2”
Hex Bolt
1/4” Dia. Clevis
Pin
Nut
Lock
Washer
1/4-20 x 1-1/2”
Hex Bolt
1/4” Dia.
Clevis
Pin
Cotter
Pin
Cotter
Pin
Control Tube
Brace
Cotter
Pin
2.