Installation
5
Pairing Function
The receiver must be registered with the transmitter on location. The following
steps are necessary for the registration:
1
. Both units must be connected to a power source - the yellow Status LED (left
hole) lights up and the green LED (middle hole) blinks every second.
CAUTION:
Receiver
Do NOT connect the
devices with the
Power Link-Source
and the speakers
yet!
Transmitter
1.
2.
Using the provided paper clips, press and hold
the buttons in the right hole of
the transmitter and the first receiver for about 5 seconds, until the green signal
LED (in the middle hole)
of the transmitter
begins to flash quickly.
Releasing the buttons
starts the pairing
function
This process
may take up to
4 minutes.
It is completed
2.
once the signal
LED begins to
blink every second.
The same registration procedure must be followed for the second receiver.
3.
Afterward, all devices must be unplugged.
