Picture 4.2 Hole positions
Installation Steps:
A) Use percussion drill to make four
Φ
4 holes on the wall according to above hole diagram.
B) Fill the holes with expanding plug
C) Put the tapping screw through the holes and fit tightly with the expanding plug,
and fasten the repeater onto the wall.
D) Make sure that the installation is firm and correct
4.3 Connection
Connection of RF cable
BTS Port : donor antenna cable is connected with BS Port;
MS Port : service antenna cable is connected with MS Port;
Grounding
Please connect one end of a copper wire with the intersection size of 16mm2 with
the grounding screw, and the other end with the grounding system of the building. It is
requested that the grounding impedance shall be less than 10Ohm.
Power supply connection
Installation of air switch is recommended for the convenience of power supply switch off.
Please use three-pin plug to assure good grounding
Please use the grounding screw, nut, washer to connect the grounding wire and
repeater shell
7
