totally the same with the user's calling number, the phone will make the call with this
number's IP address image or configuration; Another is prefix matching (be equivalent to
PSTN's district number prefix function), if the previous N bits of this number are the same
with that of the user's calling number(the prefix number length) then the phone will use
this number's IP address image or configuration to make the call. When configuring the
prefix matching, letter "T" should be added behind the prefix number to be distinguished
from the exactitude matching; the longest length is 30 bits.
Configure the calling mode: H323 and SIP;
Configure destination address, if it is point-to-point call then
input the opposite terminal's IP address, it can also be set as domain name and resolved
the specific IP address by DNS server of the phone. If no configuration has been made,
then the IP will be considered as 0.0.0.0. This is an optional configuration item;
Configure the other party's protocol signal port, this is
optional configuration item: when nothing is input, then the default of h323 protocol is
1720 the default of sip protocol is 5060; lifeline required no configuration of this item,
shown as 0;
Configure alias, this is optional configuration item it is
the number to be used when the other party's number has prefix when no configuration
has been made, shown as no alias;
Configure suffix
this is optional configuration item it
is the additive dial-out number behind the number; when no configuration has been made,
shown as no suffix;
Configure the replacing length, replace the number that user
input according to this length; this is optional configuration item;
Of which the alias can be divided into four types, it should be combined with replacing
length to make the setup:
Add: xxx, add xxx before number. in this way it can help user save the dialling length;
All: xxx, the number is all replaced by xxx; speed dialling can be implemented, for example,
user configure the dialling number as 1, with the configuration "all", the actual calling
number will be replaced;
Del: delete n bit in the front part of the number, n can be decided by the replacing length;
this configuration can decide the protocol for appointed number;
，
，
，
：
；
，
：
Charging Handset
Important Note:
YOU SHOULD
FULLY CHARGE THE HANDSET
14-16
Before initial operation,
for about
hours.
To charge the handset, you should place it on the base.
Result:
When you place the handset on the base, the handset
automatically turns on and the charging LED on
during the charge.
Using Handset Carrying Clip
The supplied handset carrying clip allows
you to conveniently carry the handset with
you. It clips easily to your belt, waist band,
or shirt pocket.
If you want to remove the carrying clip:
Insert a screw driver along the edge of
one of its arms and release the clip.
Then lift it off.
If you want to attach the carrying clip:
Attach the carrying clip to the back of
the handset. Make sure that the carrying
clip locks into place.
5
50
