2. Select "
", then click the "
".
Internet Protocol(TCP/IP)
Properties
3. Select "
", then click " ", the PC will obtain an IP
address automatically.
Obtain an IP address automatically
OK
If your LAN IP was changed, do as follow to obtain your phone's LAN IP:
1. Perform steps 1 to 3 of the last paragraph.
2. Click "
" to select "
", after inputting "
" then click " ".
3. Then a command window will pop up. After inputting "
", the window shows
as below.
The "
" is the LAN IP.
Start
Run
cmd
OK
ipconfig/all
Default Gateway
Some telephone system requires an access code (9, for example) and listen to a second
dial tone before dialing an outside number. You can set your phone to insert one-digit
access code automatically when you use a phone number from your Call ID list.
1. Press the
button.
2. Press the
or
button to choose
, then press the
button.
3. Enter the one-digit access code using the number keypad.
4. Press the
button to save the selection.
Note
:
When you dial a phone number in the Call Log list, the number will be dialed following the access
code and a preset pause time.
Setting Access Code
MENU
The handset which comes with the base unit was already registered as handset 1. Each
additional handset you purchase must be registered to the base unit.
To register a handset:
Note:
A handset can be registered to up to 4 different base units. And a base can be used with up to
6 handsets.
1. Press the
button.
3. Enter the PIN, then press the
button.
4. Press the
or
button to choose the base number you want, then press the
button.
2. Press the
or
button to choose
, then press the
button.
Note
:
The PIN is preset to "0000" at the factory. You can change the PIN. For details, see page 22. If you
want to register other handsets from different manufacturers to this base, you must enter their PIN
codes in this step.
Registering a New Handset
MENU
23
32
