BOSSVD40/BOSSVD90/BOSSVD160 User Guide
42
4-4. PTZF operation
To operate the PTZF functions, connect the controller to the RS-485 port on the rear panel.
In the PTZ control setting in the setup menu, user can select or set the protocol type of the
camera which is the same as the one that is installed on the site. If the camera has a
specific camera ID, select the camera ID using Left or Right button.
The PTZ function button is found on the front panel. Once you press the PTZ button, the
screen will appear as in figure 4.3.1. Highlight the item to select and control the cameras by
using the UP and DOWN or LEFT and RIGHT buttons. Please refer to the table 4.4.1. for
description.
Figure 4.4.1. PTZF control screen
Table 4.4.1. Button functions in PTZF control
Item
Description
PAN / TILT
Use the UP or DOWN button for TILT and LEFT or RIGHT button for PAN of
the selected camera.
ZOOM / FOCUS
Use the UP or DOWN button for ZOOM in or out and LEFT or RIGHT
button for FOCUS near or far of the selected camera.
INITIALIZE
Initialize the PTZ settings of the selected camera.