symptom
Counter measures
Tool will not cycle, the indicator
LED is green and the fan runs.
• Run out of fuel, replace a new fuel cell.
• Spark wire is loose, check the spark wire
by removing the cap.
• Spark plug is dirty. Clean the spark plug.
• If all above did not work, send to service
center near you.
Tool operate normally, but no
nail is driven
• Wrong type of nails was used. Please
change to correct nail spec.
• The cylinder needs cleaning.
• Nail is jammed, clean the jammed nail
before use.
• The nail pusher did not engage properly
with the nail strip. Adjust to fully engage-
ment.
Combustion chamber is not
returning to start position.
• The work contact element is bending or
dirty.
Check the work contact element and repair
orreplace it. Clean the safety track.
Driver did not return to initial position, miss
fire frequency get higher than usual.
• Check and replace fuel cell.
• Clean the tool with proper cleaning fluid.
• Check for piston ring wear status.
• The tool maybe over heated. Clean or
replace the intake air filter.
Tool appears to be loosing
power.
• Check fuel cell.
• Clean or replace air intake filter.
• Check spark plug wire.
• Clean the tool with proper cleaning fluid.
For failure other than above situation, please stop using the tool and contact your local
dealer for service.
11