Do not drive this tool over materials that is too hard or too soft. Hard
material can ricochet nail and hurt people, soft material may be penetrate
lubrication. Use other lubrication may cause damage to the tool and the
risk of malfunction that will injure the operator.
Please keep the tool in clean condition, wipe off grease or oil after work. Do
not use any solvent based cleaner to clean the tool. It is possible the
solvent will deteriorate the rubber or plastic components on the tool.
Greasy handle and body will cause accidental drop of the tool and injury to
nearby person.
that is not compatible to the tool will cause jamming of the tool and injury
to operator or nearby person.
Do not use the tool to perform other job than designate function. Especially
not use the tool as a hammer, impact on the tool will increase the risk of
cracked body and accidental discharge of fastener.
Remove the fuel cell and battery before performing maintenance, repair,
cleaning and jam clearing.
Load the fastener at last to prevent unexpected danger of loading fuel cell
and battery.
Never use the tool if the trigger and safety or springs are damaged in any
way.
Hold the tool only by insulated gripping surfaces. Use only fasteners
designed for electrical cable installations. Inspect that the fastener has not
damaged the insulation of the electrical cables. A fastener that damages
Fuel safety warning
Use only the fuel cell recommended by the manufacturer. Read the Safety
Data Sheet to understand more of your fuel cell contents.
Recycle the empty fuel cell according to the local law. Do not attempt to
recharge the fuel cell or incinerate the empty fuel cell.
Do not expose the fuel cell or tools loaded with fuel cell under direct sun
light exposure. Prevent to put above items at temperature higher than
Do not puncture or attempt to open the fuel cell. The fuel cell contains
source of ignition.
