Depth of drive adjustment
This tool is equipped with tool free depth of
drive adjustment. Test the depth of drive on
scrap piece before you start your work.
Turn the knob to adjust the depth of drive.
desired depth of drive setting.
This tool is equipped with single sequential trigger system only.
To actuate the tool, depress the safety against the work piece, and then pull
the trigger.
To actuate the tool again, you will need to release the safety fully and
release the trigger before you repeat above procedure.
Make sure you are driving against work piece before you pull the trigger.
Jam clearing for tool
In the case of nail jam, disconnect the power source (fuel cell and battery)
before you perform any action.
If you tool is equipped with jam clear door, open the quick jam clear door
on the side to expose the jammed nail.
If your tool is equipped with removable nozzle, press the release button and
pull off the nozzle.
Remove the jammed nail with needle nose pliers or similar type of tool. Do
not use your hand to remove the nail.
Close the jam clear door or assemble back the nozzle after you clear the
jam.
