3.2.2.9
Clearing All Sensors
You can clear all sensors from the NEST’s memory
by choosing
CLEAR SENSORS
from the System
menu. Once in the SENSOR SETTINGS> CLEAR ALL
screen tap
OK
to clear the sensors or
CANCEL
to go
back to the System screen.
WARNING –
CLEARING ALL SENSORS WILL REMOVE
THE SENSORS AND ALL SETTINGS FROM THE NEST’S
MEMORY. BE SURE THIS IS WHAT YOU INTEND TO DO BEFORE CLICKING “OK”
MISE EN GARDE –
“CLEAR ALL” D
É
GAGE LA LISTE DE CAPTEUR ET TOUT LEUR PARAM
È
TRAGE. SOYEZ SURE AVANT
DE CLIQUER “OK”
3.2.2.10
Adjust Brightness
The adjust brightness option allows you to change
the brightness of the screen to improve the read-
ability of the screen under different lightning
conditions.
*Note:
the higher level of brightness will increase
the current consumption.
You can adjust and set the screen brightness by
choosing
ADJUST BRIGHTNESS
from the SYSTEM
SETTINGS menu. In the
ADJUST BRIGHTNESS
screen use the
UP/DOWN
arrows to change the brightness level
and tap
DONE
to save the level.
3.2.2.11
Reset System Settings
The reset system settings option allows you to
restore the receiver to its default setting. You can
restore the receiver default setting by choosing
RESET SYS SETTINGS
from the SYSTEM SETTINGS
menu. Once in the RESET SYS SETTINGS screen tap
on OK to authorize the system setting reset.
2021
14
