At the SENSOR UPDATE RATE menu use the arrow
keys to move the cursor
LEFT / RIGHT
to the desired
character position. Use the
UP / DOWN
arrows to
add or subtract the minute or second numeric
options. Tap
OK
to complete or
CANCEL
to return to
settings screen.
*Note:
The sensor will finish the current cycle, then
complete one full cycle at the previous update rate prior to switching to the new update time. While the
request is waiting to be sent, three dots (…) are shown instead of the update interval.
3.2.7.3
Setting Sensor Vibration Axes
The sensors can be individually configured to
measure all three vibration axes (XYZ) combined,
a combination of, or independently. To set the
preferred option, highlight
VIB AXES
from the sensor
SETTINGS screen and tap
SELECT
.
Use the arrow keys to move cursor
LEFT / RIGHT
to
the desired character position. Use the
UP / DOWN
arrows to toggle between 1 (enabled) or 0 (ignore).
*Note:
The request is sent to the sensor at next complete update cycle. While the request is
waiting to be sent, three dots (…) are shown instead of the axes selection.
3.2.7.4
Setting Temperature Warning and Critical Alarm Thresholds
To set the desired temperature warning and critical
alarm thresholds for each individual sensor, select
the desired option from the SENSOR SETTINGS
screen,
HI TEMP / HI-HI TEMP / LO TEMP / LO-LO TEMP.
Press SELECT when the desired option is highlighted.
The bottom left quadrant of the screen will display
the current setting in Celsius (C) or Fahrenheit (F) or
DISABLED if there is no current threshold setting.
Select or modify the desired temperature by
tapping the
UP / DOWN and LEFT / RIGHT
arrows. Once the desired number, (temperature), has been selected
press
OK
to save, or
CANCEL
the editing and return to the SENSOR SETTINGS screen.
User Manual
www.bosspac.com
19
