INSTALLATION AND ADJUSTMENT
- 12 -
Operation Steps
：
1
、
Connect the power source input cable of welding machine with the output port of air switch in
electric box on the spot.
2
、
Connect the cable plug of wire feeder to the positive output of welding machine.
3
、
Connect the control cable plug of wire feeder to the aero socket on the front board of welding
machine.
4
、
Connect the negative pole of welding machine to the work piece (base metal).
.
5
、
Connect the output pipe of gas cylinder to the input joint of gas valve on the wire feeder and
clamp it.
6
、
Insert the torch joint into the output of wire feeder unit and keep the wire aim at the wire
feeder mouth.
Note: The plane of the joint should be aimed at screw, plugged tightly and rotated 90º, then
screw the bolt tightly to ensure the gun contacting closely.
7
、
Connect the shielded gas pipe of torch with the output of front panel on wire feeder.
8
、
Connect the control cable pin of torch with the two-lead aero socket of front panel on wire
feeder.
9
、
Notice that the wire diameter should be accordant with the wire wheel and torch tip and press
the wire properly with the handle.
