8 - ENG
NOTE:
Be careful not to deform the coil of nails during the loading process.
Otherwise, the nail guide door will not close and the nails might not feed
consistently.
9. Close the canister door (I) completely.
10. Close the nail guide door
(H)
making sure the
door latch
(E)
is completely engaged as shown
in Fig. 6.
ACTUATING TOOL:
To reduce the risk of injury,
ALWAYS
wear proper eye ANSI Z87.1 (CAN/CSA Z94.3)
and hearing protection ANSI S12.6 (S3.19) when
operating this tool. The tool can be actuated using
one of two modes: single sequential actuation
trigger mode and contact actuation trigger mode.
Single Sequential actuation trigger -
(Fig. 7)
Allow the tool to recoil off the work surface after actuation. If
the contact trip remains depressed a nail will be driven each time the trigger is
released and pulled, which could result in accidental actuation, possibly causing
injury.
The sequential actuation trigger’s intended use is
for intermittent fastening where accurate fastener
placement is desired.
To operate the tool in Single sequential actuation
mode:
1. Depress the contact trip firmly against the
work surface.
2. Pull the trigger.
3. Allow the tool to recoil from the work surface.
Contact actuation trigger -
(Fig. 8)
The contact actuation trigger is intended for rapid fastening on flat, stationary
surfaces.
Using the contact actuation trigger, two methods are available:
place actuation
and contact actuation.
To operate the tool using the PLACE ACTUATION method:
1. Depress the contact trip against the work surface.
2. Pull the trigger to drive the fastener.
3. Allow the tool to recoil off the work surface
To operate the tool using the CONTACT ACTUATION method:
1. Pull the trigger.
2. Depress the contact trip against the work surface. As long as the trigger is
pulled, the tool will drive a fastener every time the contact trip is depressed.
This allows the user to rapidly drive multiple fastener in sequence.
Fig. 8
C
Trigger lock button
Trigger mode selector button
Fig. 7
S
Trigger lock button
Trigger mode selector button
BRN175_9R209323_MAN_kf V2_multi.indd 8
1/28/15 7:41 AM
