12
13
some conditions and duration of use, noise from this product may contribute to hearing loss.
NOTE:
All compressed air systems generate condensate that accumulates in any drain point
(e.g. tanks, filter, aftercoolers, dryers). This condensate contains lubricating oil and/or
substances which may be regulated and must be disposed of in accordance with local, state,
and federal laws and regulations.
Risk of bursting. Drain air tank daily. Water will condense in air tank. If not
drained, water will corrode and weaken the air tank causing a risk of air tank rupture.
Risk of Property Damage. Drain water from air tank may contain oil and rust,
which can cause stains.
1. Ensure
On/Off
(A) switch is in the
OFF
position.
2. Place a suitable container under the drain valve (H) to catch discharge.
3. Grasp lever on drain valve.
4. Slowly rotate lever to gradually bleed air from air tank.
5. When Air Tank Pressure Gauge (B) reads 10 psi, rotate valve to the fully open position.
6. Tip tank back to fully drain water.
7. Close drain valve when finished.
CHECkING AIR FIlTER ElEMENT (FIG. 1)
Hot surfaces. Risk of burn. Outlet tube, pump head, and surrounding parts are
very hot, do not touch. Allow compressor to cool prior to servicing.
1. Ensure On/Off switch (A) is in the OFF Position.
2. Allow unit to cool.
3. Remove filter cover (J) from base.
4. Remove element from filter base.
5. Place new element back in filter base. Purchase replacement parts from your local dealer
or authorized service center. Always use identical replacement parts.
6. Snap filter cover to filter base.
Hot surfaces. Risk of burns. Do not operate without air inlet filter.
ACCESSORIES
The use of any other accessory not recommended for use with this tool could be
hazardous. Use only accessories rated equal to or higher than the rating of the air compressor.
Recommended accessories for use with your tool are available for purchase from your local
dealer or authorized service center. If you need assistance in locating any accessory for
your tool, please contact Bostitch Fastening Systems 701 E. Joppa Road Towson, Maryland
21286,call 1-800-556-6696.
SERVICE INFORMATION
Please have the following information available for all service calls:
Model Number _____________________ Serial Number _______________________________
Date and Place of Purchase ____________________________________________________
REPAIRS
To assure product
SAFETY
and
RElIABIlITY
, repairs, maintenance and adjustment should be
performed by a BOSTITCH factory service center, a BOSTITCH authorized service center or
other qualified service personnel. Always use identical replacement parts.
FUll ONE YEAR WARRANTY
B
OSTITCH heavy duty industrial tools are warranted for one year from date of purchase. We will
repair, without charge, any defects due to faulty materials or workmanship. For warranty repair
information, call 1-800-556-6696. This warranty does not apply to accessories or damage caused
where repairs have been made or attempted by others. This warranty gives you specific legal
rights and you may have other rights which vary in certain states or provinces.
laTIN amerICa:
This warranty does not apply to products sold in Latin America. For products sold
in Latin America, see country specific warranty information contained either in the packaging,
call the local company or see website for warranty information.
Free WarNING laBel rePlaCemeNT (FIG. 4):
If your warning labels become illegible or are missing,
call 1-800-556-6696 for a free replacement.
