Loading the Staples:
1. Pull the pusher all the way back.
2. Allow the pusher to rotate down into
notch in magazine.
3. Load the staples.
4. Slide the staples all the way forward.
5. Pull back on the pusher.
6. Allow pusher to rotate up out of
notch in magazine.
7. Allow pusher to slide foreword in
contact with the staples.
EYE PROTECTION which conforms to ANSI specifications and provides protection
against flying particles both from the FRONT and SIDE should ALWAYS be worn by
the operator and others in the work area when loading, operating or servicing this
tool. Eye protection is required to guard against flying fasteners and debris, which
could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye
protection equipment must conform to the requirements of the American National
Standards Institute, ANSI Z87.1-1989 (R1998) and provide both frontal and side
protection. NOTE: Non-side shielded spectacles and face shields alone do not
provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool while the air supply is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
LOADING THE SB150SLBC
6
1
2
4
3
5
6
7
