TOOL OPERATION CHECK:
CAUTION: Remove all fasteners from tool before performing tool operation check.
1. Trigger Operated Tool:
A. With finger off the trigger, hold the tool with a firm grip on the handle.
B. Place the nose of the tool against the work surface.
C. Pull the trigger to cycle the tool. Release the trigger and cycle is complete.
CAUTION:
THE TOOL WILL CYCLE EACH TIME THE TRIGGER IS PULLED!
2. Automatic Tool:
A. With finger off the trigger, hold the tool with a firm grip on the handle.
B. Place the nose of the tool against the work surface.
C. Single cycle mode:
Lightly pull the trigger for a single cycle. Release the trigger and cycle is complete.
CAUTION:
THE TOOL WILL CYCLE EACH TIME THE TRIGGER IS PULLED!
D. Automatic mode:
Pull trigger as far as possible to depress both valve stems. Release the trigger to stop.
CAUTION:
THE TOOL WILL CYCLE AT UP TO 30 TIMES A SECOND IN AUTOMATIC MODE.
-9-
IN ADDITION TO THE OTHER WARNINGS CONTAINED IN THIS MANUAL OBSERVE
THE FOLLOWING FOR SAFE OPERATION
• Use the BOSTITCH pneumatic tool only for the purpose for which it was designed.
• Never use this tool in a manner that could cause a fastener to be directed toward the user
or others in the work area.
• Do not use the tool as a hammer.
• Always carry the tool by the handle. Never carry the tool by the air hose.
• Do not alter or modify this tool from the original design or function without approval from
BOSTITCH, INC.
• Always be aware that misuse and improper handling of this tool can cause injury to
yourself and others.
• Never clamp or tape the trigger or contact trip in an actuated position.
• Never leave a tool unattended with the air hose attached.
• Do not operate this tool if it does not contain a legible WARNING LABEL.
• Do not continue to use a tool that leaks air or does not function properly. Notify your nearest
Bostitch representative if your tool continues to experience functional problems.
