Vercise™ DBS Programming Manual
91053785-17 27 of 1705
Programming the Patient
en
Increasing and Decreasing the Pulse Width
The pulse width of the stimulation describes the length of time a burst of energy is
applied to the desired area. The pulse width is measured in microseconds (µS).
1
To increase the pulse width, click or click and hold the
button below the PW
label on the Programming Screen.
Note:
If you attempt to adjust the pulse width above the charge density limit, then
you will see a caution message.
2
To decrease the pulse width, click or click and hold the
button below the PW
label.
