5-5
Section 5 • Care & Maintenance
345 Conquest
NOTICE
NEVER use abrasive cleaners, detergents or soft
scrub type cleaners to wash your boats surfaces.
NEVER use abrasive pads, brushes or sponges
to attempt to remove stubborn stains.
NEVER use strong solvents or detergents which
contain chlorine.
NEVER use silver cleaners.
Preventative maintenance is essential to life of the
metals on your boat. The presence of salt particles
and moisture is the major cause of white spots, pitting
and corrosion.
The use of harsh chemicals can also cause deterioration.
Manufacturers and applicators of protective coatings
will not warrant protective coatings on metals in the
Aluminum Care
• Dry thoroughly.
• Apply cleaning wax with a soft, dry cloth.
• Allow wax to dry, then polish and buff.
Even the finest cleaning powders can scratch or
burnish a mill-rolled surface. On polished finishes,
rubbing or wiping should be done in the direction of
the polish lines, NOT across them.
Crevice corrosion, a brownish coloring which occurs
where two pieces of stainless hardware meet is
caused by impurities in water and air. It can be easily
cleaned with a good grade marine polish using a
sponge, cloth or small bristled brush (for nooks and
crannies).
marine environment. Proper owner maintenance is
required to reduce deterioration which will result in
most cases by failure to wash down and wipe dry
after each use and/or the use of abrasive, acidic or
other improper cleaners.
Wash completely using a soft cloth and mild
detergent to remove salt particles. Hosing alone will
not dislodge all particles.
DO NOT
allow soap to dry
as it may cause stains on coated surfaces. Make sure
to wash and dry the full circumference of aluminum
parts.
Apply an aluminum protectant at least twice each
year, more frequently as conditions warrant. Neglect
will cause pitting of the surface which cannot be
reversed.
Inspect and repair or replace all damaged nylon
bushings, washers or other hardware designed to
prevent contact with dissimilar metals.
Whenever electrical or electronic changes are made
to the boat, a qualified marine technician should
check aluminum parts for stray currents. Make sure
all electronic equipment is properly grounded with
adequate sized wire.
Cushions
Saltwater, salt residue, dirt, ultra-violet rays etc. will
take their toll on vinyl products causing them to lose
their luster and texture.
The cushions on your boat are made of a durable
vinyl material called OMNOVA which is protected
by a finish called PreFixx
®
. PreFixx will keep your
cushions looking new far longer than most other
vinyl upholstery.
To Clean Your Cushions
Solvents are flammable. Exercise proper care.
Wear rubber gloves during all cleaning activity.
Use caution when cleaning around buttons,
stitching and wooden or decorative trim as
these solvents could seriously damage such
areas.
!
CAUTION
Seats (Mechanical Parts)
Always wash metallic parts with soap and water
and rinse thoroughly with fresh water. Once
dry, apply a light coating of lubricant to protect
moving parts.
Check for loose or damaged hardware and
tighten or replace as necessary.
Summary of Contents for CONQUEST 345
