Declaration of conformity
Sourcing& Creation hereby declares that the device is in conformity with the essential requirements of
Directive 2014/53/EU.
Changes or modifi cations not expressly approved by Sourcing&Creation could void the user’s authority to operate the
equipment.
FCC part 15 compliance statement
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception which can be determined by turning the equipment off and on, the user is encouraged to try to correct interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on circuit diff erent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Industry Canada Licence-Exempt Radio Apparatus
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur
de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.
Radio Frequency (RF) Exposure Compliance of Radiocommunication Apparatus
To satisfy FCC and IC RF Exposure requirements for mobile devices, a separation distance of 20 cm or more should be
maintained between the antenna of this device and persons during operation. To ensure compliance, operation at closer than
this distance is not recommended. This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
Conformité à l’exposition aux champs RF des équipements radio
Pour satisfaire aux exigences FCC et IC concernant l’exposition aux champs RF pour les appareils mobile, une distance de
séparation de 20 cm ou plus doit être maintenu entre l’antenne de ce dispositif et les personnes pendant le fonctionnement.
Pour assurer la conformité, il est déconseillé d’utiliser cet équipement à une distance inférieure. Cet émetteur ne doit pas être
co-situé ou fonctionner conjointement avec une autre antenne ou un autre émetteur.
- Frequency Band: 2400-2483.5MHz
- Maximum Transmitting Power : 100mW (EIRP)
For plug only (metallic parts) :
WARNING
: This product can expose you to chemicals including Pb, which is known to the State of California to
cause cancer or birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
