• Remove excess foliage from your cuttings to help reduce wilting
from transpiration and direct the plants energy to root development.
• Trim the stem of the cutting at a 45 degree angle to increase surface
area for rooting.
• If taking multiple cuttings, store the cuttings in purified water until
ready to transplant into your Power Cloner.
3. Place cuttings in Power Cloner
• Gently place your cuttings into the neoprene collars. Make sure 1 inch
of the cutting sits below the collar and 2 inches above.
• Place the neoprene into the Power Cloner lid holes.
• If your Power Cloner comes with a Humidome, place it on top of the lid.
• Turn on your Power Cloner and allow to run continuously for 5-7 days.
• Ensure the water temperature does not rise above 75 degrees.
(Maintaining an ambient room temperature of 72-76 degrees can help
keep water temperature under control.)
• Use a low intensity fluorescent light if ambient light is insufficient.
• Your clones should be rooted and ready to transplant in 5-7 days.
45˚ angle
neoprene
2”
1”
