Determining the XRD Hardware ID
The Botlink XRD’s Hardware ID is needed to register a Botlink XRD to an account. This is
written to a file at the root of the SDCard file system every power cycle.
To view the Hardware ID, do the following:
1. Insert a microSD card into the microSD card reader in your Botlink XRD
2. Power on your XRD
3. Wait 1 minute
4. Power down your XRD
5. Remove the microSD card from the microSD card reader in your Botlink XRD
6. Insert the microSD card from your Botlink XRD into the microSD card reader on your
device
7. View the contents of your micro SD card on your device
8. Open the file named XRD_HARDWARE_ID using Notepad
9. The contents of the file will be the Hardware ID of your Botlink XRD
Determining Software Version
The software version of the Botlink XRD is written to a file at the root of the SDCard file system
every power cycle.
To view the software version of the software installed on your Botlink XRD, do the following:
1. Insert a microSD card into the microSD card reader in your Botlink XRD
2. Power on your XRD
3. Wait 1 minute
4. Power down your XRD
5. Remove the microSD card from the microSD card reader in your Botlink XRD
6. Insert the microSD card from your Botlink XRD into the microSD card reader on your
device
7. View the contents of your micro SD card on your device
8. Open the file named XRD_OS_VERSION using Notepad
9. The contents of the file will be the software version of the software on your Botlink XRD
Software Updates
The Botlink XRD software can be updated using an SDCard. The update process should take
about 5 minutes.
18
