Bot’n Roll ONE A User Assembling Manual
4.1.1. MOTORS
The setng of each motor is performed using a motor
support with two M3 embedded nuts, three M3x6mm
PH1 screws and two M3x12m PH1 screws.
You need a 1.5mm hex wrench included in the
mechanical components bag and a Phillips PH1
screwdriver (not supplied).
Fix the motor to the support using the three smaller
M3x6mm PH1 screws.
Use the Phillips PH1 screwdriver to tghten all three
screws conveniently.
Fix the support with the motor to the acrylic base using
the two longer M3x12mm PH1 screws and M3 nuts
embedded in the support.
The acrylic base has a hole to pass the motors wires to
connect later on to the printed circuit board. Introduce
the wires into the hole according to the image.
©Copyright 2018, SAR - Soluções de Automação e Robótca, Lda.
13
Fig. 7: Required equipment to set
the motors
Fig. 8: Fixing the L shape motor support to the
motor itself
Fig. 9: Fixing the motors to the acrylic base
Fig. 10: Passing the motors wires through the
acrylic base
Summary of Contents for ONE A
Page 1: ......
