Position & orientate the
Floorstanding pole in the
location of final install.
Mark the drill hole
locations on the
mounting surface.
Drill all four fixing holes
into the mounting
surface.
Locate the Floostanding
Slim Cover over the
Floorstanding Pole.
Locate and secure the Case onto the
Mounting Arm as shown. Tighten by
hand.
Feed the tablet power cable
through the Bouncepad Case and
Floorstanding Pole.
Fixings Kit
Tablet Set-up Kit
Faceplate
Case
Sheet Code:
BP-IM-048_REV2
Release Date: 28/10/2019
Copyright 2016 Spotspot Ltd. (T/A
Bouncepad) all rights reserved.
Confidential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
1
2
3
4
5
7
Floorstanding
Rubber Collar
Floorstanding
Pole
Front
*Drill bit type & size is determined
by your chosen fixing method.
*Fixings to secure the Floorstanding
Pole are not provided.
Case Washer
M4 Split Washer
Floorstanding
Slim Cover
Pair of Keys
4x M4x20mm
Buttonhead
screw
4x M4 Split
Washer
1x Case
Washer
Fixings List
* Due to the modular nature of our product range
you may receive additional fixings in the fixings kit
Floorstanding Slim
Assembly Instructions
In the Box
Unlock & remove the Faceplate from
the Bouncepad Case.
6
Tools Required:
M4x20mm Button head screw
Tighten screw(s) using hand tools, using electric
tools may damage your Bouncepad.
1x T20 Pin
Torx Driver Bit
T20 Pin Torx Driver Bit
Socket Driver
Pencil
Drill
*or adjustable spanner
Drillbit
*Please note that the drillbit size & type will be
determined by your chosen fixing method and
material of the mounting surface.
Ensure you have access to the appropriate tools
to secure the Floorstanding to your mounting
surface.
*Bouncepad does not provide these fixings.
