Feed the tablet power cable through
the Case & Floorstanding Pole.
11
Locate and secure the Case onto the
Mounting Arm as shown. Tighten by
hand.
9
Case Washer
M4x20mm Button head screw
M4 Split Washer
T20 Pin Torx Driver Bit
Tighten screw(s) using hand tools, using electric
tools may damage your Bouncepad.
4x Corner Pieces
1x Cable Clip
4x Tablet Supports
12
Install the Tablet Setup Kit. Each kit is
specific per device & case.
Install the tablet into the Case &
connect to power.
13
Feed power cable through Printer
Mount and plug into Printer
6
7
Re-attach Neck-Ring
Pull cable back to remove any slack
near the Printer Mount
8
Unlock & remove the Faceplate from
the Bouncepad Case.
10
14
Locate and lock the Faceplate to the
Case.
