Mount Washer
M4 Split washer
M4 Wing Nut
Mount Washer
M4 Split washer
M4 Locking Nut
7mm Spanner
Sheet Code:
BP-IM-029_REV2
Release Date: 28/10/2019
Copyright 2016 Spotspot Ltd. (T/A
Bouncepad) all rights reserved.
Confidential, no part of this publication
may be reproduced or transmitted in any
form without the written permission of the
copyright holder.
Static60
Mounting
Arm
Faceplate
Case
Fixings Kit
Tablet Set-up Kit
Follow steps A if “Fixing
from below”.
A
Follow steps B if “Fixing
from Above”.
B
Locate and screw the Socket
screws into the Static60 as
shown
Secure the arm to the
surface. Locking Nuts
offer higher security.
Go to step 1.
A3
A4
A5
Using the Mounting
washer, mark the drill
hole locations as shown.
A1
Front
Using the Mount Plate,
mark the drill hole
locations as shown.
B1
Mount Plate
Front
4x
Ø
2.5mm
1x
Ø
16.0mm
Surface
Mounting Kit
25
mm
Metric
Imperial
1"
Maximum Mounting
surface thickness :
34
mm
Metric
Imperial
1
5/16"
Minimum Mounting
surface thickness :
4x
Ø
5.0mm
Drill each hole -
using the specified
drill size.
A2
Ø
5.0mm Drillbit
Ø
16.0mm Holesaw
1x
Ø
16.0mm
Mount Washer
Front
In the Box
Static 60
Assembly Instructions
Tools Required:
Pencil
Electric Drill
16mm
Holesaw
*if routing the tablet
cable through your
mounting surface
7mm Spanner
*or adjustable spanner
2.5mm Drillbit
*if fixing from above
5.0mm Drillbit
*if fixing from below
Pair of Keys
4x No.8
Countersunk,
Self tapping
Screw
4x M4x40mm
Socketset
screw
4x M4x20mm
Buttonhead
screw
4x M4x10mm
Countersunk
Screw
8x M4 Split
Washer
4x M4
Locking
Nut
1x Case
Washer
1x Mount
Washer
4x M4
Wing Nut
Tighten screw(s) using hand tools, using electric
tools may damage your Bouncepad.
*see overleaf
Tighten screw(s) using hand tools, using electric
tools may damage your Bouncepad.
Drill each hole - using the specified
drill sizes.
B2
Ø
2.5mm Drillbit
Ø
16.0mm Holesaw
Fixings List
* Due to the modular nature of our product range
you may receive additional fixings in the fixings kit
Socket Driver
1x T20 Pin
Torx Driver Bit
