20
GROUND BALANCING
MANUAL GROUND ADJUSTMENT
Refer to the
GROUND
section of the manual for instructions on how to manually
adjust the detector’s internal Ground setting.
If the Ground setting is incorrect, there will be a difference in the sound as
the searchcoil is either moving toward or away from the ground. It sounds
like you are either pulling the sound out of the ground, or pushing the
sound into the ground.
• If the sound gets louder as you raise the searchcoil, increase the
Ground setting.
• If the sound gets louder as you lower the searchcoil, reduce the Ground
setting.
NOTE: Experienced users often prefer to adjust the Ground setting to
get a weak but audible response when lowering the searchcoil. This is
called “adjusting for positive response.”
HEADPHONE JACK
Push the tab up and lock into place to
expose the headphone jack.
This detector has a 1/4” headphone jack.
It works with any stereo headphone that
has a 1/4” plug.
When the headphone jack is connected,
speaker volume is disabled.
USING HEADPHONES
Using a detector with headphones facilitates detection of the weakest signals
and also extends battery life.
It also allows you to hear subtle changes in the sound more clearly, particularly
if searching in a noisy location. For safety reasons, do not use headphones
near traffic or where other dangers are present. This device is to be used with
interconnecting cables/headphone cables shorter than three meters.
SWIVEL
DOOR
