5 Operation
32
Operating Manual ARC 400
900-400_IFU_V1.0.0.6.17.9_20140-S2-20130604-EN
Press the "Back" button to return to the main screen without changing the
selection.
If a mode is changed within a socket, the set parameters, e.g. effect and
max. Watt, remain the same for the respective mode. However, if, for
example, the factory default setting of a mode is adapted and
subsequently changed to a different mode and then back again, the user
changes are not undone.
5.4.2. Specifying power limits
Figure 5-8: Power limit monopolar cutting
1. To select the maximum current for monopolar cutting, first select one of the
two socket connectors on the left side and press the yellow icon under the
“max. Watt” button.
2. Use the "+" and "-" buttons to adjust the power level in single steps.
– or –
Use the slider to set the power level in steps of 10.
3. Press the "?" button for more information on this selection.
4. Confirm your selection by pressing the "OK" button.
- or -
Press the "Back" button to return to the main screen without changing the
selection.
