Assembly / Owner’s Manual
44
Custom
(Open-ended workout, 1 minute each column or saved workout)
The Custom workout program allows a user to “design as you go”, adjusting the currently
active incline segment of each column. When the workout ends, the workout will be as-
signed to the Custom program.
In addition to the “design as you go” option, a completed workout can be saved as the Custom program. All modifications to the workout segments
are saved, allowing the same workout to be repeated by selecting the Custom workout.
Note:
Once a completed workout is saved as a custom workout, it may be desired to reset the program. To reset the Custom program, push
and hold for 3 seconds the Custom button. The Console will display RESET CUSTOM YES. Push Enter to reset, or PAUSE/STOP to
exit reset option.
Starting a Workout
To begin a workout:
1. Review the currently selected User Profile. Push the USER button to change the active User Profile.
2. Mount the machine.
3. Push the button for the desired Program Workout. The Console will show the selected workout.
4. Push the START button.
Your workout will begin after the three second, audible beep countdown.
Note:
Be sure to read the “Getting Started” section of your manual.
During a Profile Program workout, the Console will make an audible beep when the next segment of the workout occurs. Be
prepared for changes in Resistance with each segment change.
If during a workout the User pushes one of the Program buttons, the Console will ask if they would like to switch workouts. If the User confirms
the switch by pressing the ENTER button, the current workout will be ended. The new workout program will be displayed, and will begin when the
START button is pushed.
Changing Incline Levels
Push the Incline Level Increase(
) or Decrease(
) buttons to change the incline angle of the rail assembly at any time in a workout program. To
rapidly change the incline level, push the desired Incline Level Quick Button. The Console will adjust to the selected incline level of the quick button.
Be sure the area below the machine is clear before lowering. Fully lower the Incline Assembly after each workout.
Exercise on this machine requires coordination and balance. Be sure to anticipate that changes in resistance levels and incline
angle of rail assembly can occur during workouts, and be attentive in order to avoid loss of balance and possible injury.
Be sure that the workout space you are utilizing has adequate height clearance, taking into consideration the height of the user and
the maximum height of the fully inclined Rail Assembly.
Summary of Contents for BXE226
