Assembly / Owner’s Manual
59
Condition/Problem
Things to Check
Solution
Belts stop turning while in use
Safety key
Plug Safety Key into Console (See
Emergency Stop Procedure in Safety Warn
-
ing Labels section).
Motor overload
Unit may be overloaded and drawing too much current, causing unit to shut
power down to protect motor. Consult belt lubrication schedule to determine
if belts need lubrication, check walking belt tension, and restart unit.
Outlet
Outlet may not have enough power available for the machine due to other
devices on same circuit. Remove any devices from power circuit and restart
machine.
Console displays “INSERT
SAFETY KEY”
Safety Key
Insert Safety Key into Safety Key Port on Console.
Console displays “NOTE
LUBRICATE BELT” followed by
“REVIEW USER MANUAL”
Belt lubrication
Consult lubrication schedule and apply if necessary. Push ENTER button to
exit the notice.
Console displays “ERROR
COMMUNICATION” followed by
“RESTART MACHINE”
I/O Cables
Restart machine. If error persists, contact Customer Service for further as-
sistance.
Console displays “ERROR
MOTOR BOARD” followed by
“CONTACT SUPPORT”
Motor Control Board
Contact Customer Service for further assistance.
Console displays “ERROR
OVERLOAD” followed by “COOL
DOWN 20 MIN”
Motor Covers
Cycle power off and allow the machine to cool down for at least 20 minutes.
Be sure the Motor Cover vents are free of debris. If issue recurs contact
Customer Service for further assistance.
Console displays “ERROR MO-
TOR WIRE” followed by “CON-
TACT SUPPORT”
Motor Connections
Contact Customer Service for further assistance.
Console displays “ERROR
STUCK BUTTON” followed by
“Name of BUTTON”
Specified button
Release specified button. If error persists, make note of the stuck button and
contact Customer Service for further assistance.
Console displays “PLEASE
CYCLE POWER” and one of the
following: “MCB COMM LOST”,
“MCB RELY STUCK CLSD”,
“MCB RELY STUCK OPEN”,
“MCB TACH OVER SPEED”,
“MCB TACH TIMEOUT“, “MCB
COMM TIMEOUT”, “MCB OVER
CURREN SOC”, “MCB OVER
CURRE CRIT”, “MCB OVER
CURRE DMAG”, and “MCB HW
OVERS SPEED”
Motor Control Board
Restart machine. If error persists, contact Customer Service for further as-
sistance.