background image

03 

 

Use of the clay pigeon traps

 

With all three tasks complete, the trap is now ready to connect to the battery. Do not add clays into the hoppers at 
this point. When preparing to connect to the battery move to a safe position at the rear of the trap and make sure 
that NO

-

ONE is in the DANGER ZONE in front of the trap or inside the area marked out by the safety ring. 

 

Connect the radio receivers to the green sockets on the traps, check that the control box switches are in the off 
position and then connect the crocodile clips to the battery. To arm the traps, turn the program switches to 

on run, 

the traps will power up and the motor will rotate the throwing arms and stop in the firing position. Fire the trap by 
pressing the wireless control (notice that the traps re

-

arm themselves ready to fire again). Now you must disarm the 

traps in order to load clays and make elevation adjustments. 

 

Disarm and make safe

 

To disarm and make the traps safe you 

flick

’ 

the program switches to 

nudge fire

’. 

Notice the traps will fire, but do 

not re

-

arm with the throwing arms visible to the left. Remove the crocodile clips from the battery. Load your clays 

gently into the hoppers, being careful not to drop them onto the spike (wet clay separator). To make elevation 
adjustments, release the lever lock, tilt the trap backwards to the desired height and then re

-

tighten the lever lock. 

Now you are ready to re

-

attach the crocodile clips (ensuring the program switch is set to 

off

’) 

and then switch the 

program to 

on run

’ 

in preparation to fire clays. 

 

Note: When the traps are armed and ready to fire, turning the program switches to off will not make them safe, they 
MUST be de

-

cocked using nudge fire and the power source removed before being completely safe. 

 

 

 

  

 

 

 

Operating the wobble base

 

To operate your wobble base connect to a 12v battery. Moving the switch to the right will nudge the traps in small 
increments and  clicking it fully over to the left with engage continuous left to right movement. You can run the 
traps and movement from one battery   however the battery will loose charge quicker. There are two battery trays 
on your mini game trailer if you prefer to the run the system off two batteries. 

 

Summary of Contents for MINI GAME TRAILER






Reviews: